Shop

General:

• Bag width: no specified range.
• Bag length: 4″ to 13″
• Seal style:
  • 1/8″ wide final trim seal with trim 1/4″ above.
  • 3/8″ wide final trim seal with trim 1/8″ above.
• Materials accepted: Polyethylene, polypropylene, foil poly, kraft poly, laminations, Tyvek, Mylar, and shrink films. Polypropylene seals without angel hairs.
• Conveyor belt width: 12″
• Conveyor belt length: 8′ – 0″
• Conveyor belt speeds: Variable with the incorporation of an AC motor controller with speeds up to 100 fpm. Sealing bands are mechanically synchronized to drive on ledge and transport conveyors.
• Ledge conveyor: Motorized belt, 2-5/8″ wide that runs entire bed length of transport conveyor.
• Seal band: ½” wide X 40″ long x 8 mil., medium duty Teflon sealing bands with reinforced butt splice.
• Carry belts: Two sets of ½” wide urethane flat belts that are located on either side of the seal bands. This ensures that the substrate is positively held during all phases of sealing and trimming.
• Sealing drive: Heavy duty gears and stainless-steel shafting throughout.
• Sealing assembly: One heating and cooling section is provided to transfer the thermal energy to seal and then remove it. Each assembly consists of chrome plated brass seal bars with a nickel-plated cooling section. Heating section consists of a 5″ long lower bar with a 305 W element and two 2-1/2″ long upper bars, each with a 125 W element.
• Temperature control: Digital readout temperature controller with maximum temperature of 500 degrees F and repeatability of +/- 2 degrees.
• Scrap removal:
  • Supplied with ½ Hp vacuum blower, 120 VAC with 5″ flexible hose and stainless-steel oval flanged nozzle at inlet. Scrap is directed into a 3 ft long knit bag.
  • Supplied with 1 Hp vacuum blower, 120 VAC with 6″ flexible hose and stainless-steel oval flanged nozzle at inlet. Scrap is directed into a 3 ft long knit bag.
• Trim: Long life, titanium nitride coated, 2″ diameter, counter-rotating knife blade is located at the discharge following sealing.
• Footprint dimensions: 24″ W x 8′ L

Features:

• Complete with automatic scrap removal and polyester mesh bag scrap accumulator.
• Powered by variable speed, brushless vacuum motor.
• Preheat design on Smokeless and odourless models thus eliminating warm up time.
• USDA approved
• Air supply: No compressed air required.
• Compatibility: Designed to operate with all Speedy Bag Packager models or other fully automatic bag loading systems.

Structure:

• Welded heavy duty chassis steel construction.
• Stainless steel contact surfaces.
• Quick and accurate length adjustments are accomplished in seconds.
• Supplied with locking, swivelling casters and tilting conveyor bed surface.

Electrical Requirements:

120 volt, 1 amp, 1 phase, 60 cycle

Options:

• Single and double line embossing encoder.

• Bag/product pull-in device.
• Product compression belt.
• Product counters.
• Mirror image (left to right flow).
• Stainless steel stand.
• Conveyor lengths of to 40 feet.
• Available in conveyor base widths of 24″ and 36″.
• 240-volt supply.
• Casters